Hello, I have a problem with a roller shutter controller and a pulse/bell switch, despite several attempts I am unable to connect the controller to make it work properly. Please help. I have connected:
Controller N -> N from mains
Controller L -> L from mains
Controller M up -> roller shutter motor
Controller M down -> roller shutter motor
Control up -> pulse/bell switch
Control down -> pulse/bell switch
Converter -> L from mains
There is phase, neutral and earth going directly to the roller shutter motor.
Would be grateful for answers.
Controller N -> N from mains
Controller L -> L from mains
Controller M up -> roller shutter motor
Controller M down -> roller shutter motor
Control up -> pulse/bell switch
Control down -> pulse/bell switch
Converter -> L from mains
There is phase, neutral and earth going directly to the roller shutter motor.
Would be grateful for answers.
Moderated By p.kaczmarek2:3.1.12. Publishing the same or very similar information in multiple forum sections.
Duplicate: Bell switch roller shutter controller - how to wire correctly?
