ULN2803 Parallel Outputs: What Happens If Only One Input Is High Per Channel?

Hi,
I have 5 uln2803 connected as following
All outputs of chanel 1 from each chip are toghether
The inputs are separated, like 5 inputs and 1 output
All the other channel are the same
What is happen when 1 chp has chanell one low -(input= high) and other 4 hasw the same output but high (input = low)At any time , gust one output per chanel is High, the other are Low ?
Please reply to igeorge(_at_)rogers.com
Thank you

Diagram ??

This is a simplified circuit.
I have leds which work on 5 volts , no resistor.

Next Truth table ?? Im showing you how to solve this yourself

Good Carry on !!

After this datasheet ?? I want you to tell me what the max Current is per switch on each IC thats the Collector emmitter current of each transistor in the array of the ULN device ? what is the current max for each of the ouputs of the Ic when the input for that selected output is set to true

Next your going to tell me what your maximum led current is per led

Next your going to tel me what happens when you use to tansistors in parralell for collector emiter current sharing

Next your going to tell me what happens in a darlington array and what the hfe works out to be for a given I B

Next your also going to tell me what the maximumim input voltage is and what the maximum input current should be for a given output sink current

finally your going to tell whats wrong with your circuits and why it works or doesent work which eever it is that you decide on after you have answered these above questions and how you arrived at your decision

Very easy this shoulnt be difficult for you at all

After this you will be saying why the hell couldnt i do this myself