Zigbee interface

Dear friends,

I am new to embedded development. so please any one give a idea for my project.

My project theme is , i have to measure some readings by sensors. The sensor is connected with pic microcontroller and it transmits the readings to another one receiver which is already connected with another one pic microcontroller. This transmission is done by zigbee(wireless protocol). because the transmitter part is placed with a drum which is continuously rotating with the help of motor.

My problem is, another two drums also having the same setup. when a transmitter transmits the data, the specified receiver module only should receive the data.
(i.e)
1. TX(a) to RX(a) ,
2. TX(b) to RX(b) ,
3. TX(c) to RX(c) .

please give your suggestions to me.


Thanks in advance.

It would be very helpful if you provide the zigbee chip or module you are using. Many of the ones I've seen have the ability to be configured with a unique address or network address, so that you can use many separate networks like you want, A, B, C, etc.

Here is a link I just found:

https://learn.sparkfun.com/tutorials/exploring-xbees-and-xctu/configuring-networks

Great !

I got some idea about my project from that link.

Thanks for your reply.