* I refer LTC-2941 datasheet and configure DC-1496-A board into our EVK1104 board and also connect one 9V battery(for testing purpose)into E2 and E4 pin(DC-1496 board).
* I write code and check the output,the data can be read,but 80h and 81h only reads again and again in Status and ACR(C,D)(page no:12).But the page no:7,the C reg have 7Fh and D reg have FFh.
* And my query is the reading values is correct or not? Which value should be read?Or if this value constant for this battery(9V) or all types of batteries.
* And also we try to write the value(FC) in control register, but we get the previous value(0x81).
* Please suggest me ,Because if this output is correct we are going to make next level,Kindly reply me as soon as possible.
* I write code and check the output,the data can be read,but 80h and 81h only reads again and again in Status and ACR(C,D)(page no:12).But the page no:7,the C reg have 7Fh and D reg have FFh.
* And my query is the reading values is correct or not? Which value should be read?Or if this value constant for this battery(9V) or all types of batteries.
* And also we try to write the value(FC) in control register, but we get the previous value(0x81).
* Please suggest me ,Because if this output is correct we are going to make next level,Kindly reply me as soon as possible.
