I would like to know how can I use an digital programable time for a 2 different DC motors that should work on 2 seperate times + a surface burner that should heat up in a seperate time aswell . Basically i would like all three of them use the same digital progamable time switch but each will work in seperated times. if not possible what advice can you give me. what I exactly want is the following: first i want the programable to start a dispensencer using a DR motor, 5 seconds after dispensing I want the surface burner to heat up for 10 minutes or so, then the second DC motor should start. I hope I am clear thanks.
