Designing a Parallel Wire Conductivity Meter for Testing 10 Individual Connections

Hi all,

Actually am looking to test the connectivity of the wire,a set of wires(eg.10 wires) which is arranged in parallel. I need to test and conform all wires have perfectly connected(i.e individual wires should have the connectivity).Here i attached the image below.Kindly give me a suggestion.

Thanks and regards,
Santhoshkumar

Hi,
I have a bit of confusion with your title and the subject matter. If you want to check the connectivity of the wires. You could always just use a multimeter and check each wire if its connected.

But when you say conductivity, well that is another story.

Cheers,
Kevin

Hi Kevin,
What you said is right,sorry for your confusion. Thanks for reply, actually my application is to test the wires and ensure that the wires are perfectly connected. Already i attached the image in previous post its a set of wires connected and terminated into two points. If any one of the wire is broken or not connected that the thing i need to find out. You told to use multimeter to check the connections, its not a problem for a single device but i need to use this method for a continuous process. That's why am asking a suggestions from you guys...

Santhoshkumar.