Bosch SPV43M10EU / 30 dishwasher - error E19 pops up immediately after switching

Hello. I'm new here and please bear with me. I have a problem with the Bosch dishwasher. After pressing the on button, the error E19 immediately pops up. The dishwasher does not react. I read on a foreign forum that it could be a solenoid valve. I cleaned it as described, but nothing helped. And I have a question before buying a second one. Has anyone had a similar problem and knows what could be? Because it's hard to find anything else about this error. Thanks in advance!

According to the instruction of the Cold Column it is:

Error code E19
Symptom: There is no response to the control keyboard.
Cause: Damaged service module, damaged software.

Can it be checked somehow? Because, as I can imagine, it will not cost much ... ?

Advice not to let anyone get hurt - I absolutely do not take any action while the device is connected to the power supply! (to the socket) :!:

First you have to get to the controller module (it's in the dishwasher door) and check all connectors, disconnect and clean it and reconnect. Check the driver board itself if there is something burned (take photos of the driver and add it as an attachment to the post).

Hello
I have the same problem and I have located a damaged solenoid valve. The place of installation of the solenoid valve can be viewed in another post:
https://www.elektroda.pl/rtvforum/topic3432807.html
Please let me know if the coil resistance in the Siemens SPV43M10EU / 30 model is to be 7 ohms?
Thanks