Noel
Set your ohmmeter to the R x 10,000 setting.
Connect the negative lead of your ohmmeter to the anode of the SCR and the positive lead to the cathode of the SCR.
Read the resistance value that is displayed on the ohmmeter. It should read a very high value of resistance. If it reads a very low value, then the SCR is shorted and should be replaced.
Switch the leads on your ohmmeter so that the positive lead is connected to the anode and the negative lead is connected to the cathode of the SCR.
Read the resistance value that is displayed on the ohmmeter. It should read a very high value of resistance. If it reads a very low value, then the SCR is shorted and is not good.
Touch one end of a short jumper wire to the anode of the SCR and at the same time touch the other end of the jumper wire to the gate of the SCR. If the SCR is working correctly, the reading will be a very low resistance value. The value will remain low even if you disconnect the jumper wire. However, in a properly working SCR, if you disconnect either of the ohmmeter leads the resistance will return to a very high value even when the lead is reconnected unless you short the anode to the gate again. If your SCR behaves as described in the case where you short the gate to the anode and in the case where you remove and replace an ohmmeter lead, your SCR is working correctly.
