I have a Foscam FI891w IP cam that is stucked in a Reboot loop. It always connects with no image, then reboots and reconnects for 9 to 10 seconds then reboots. It’s a never ending cycle.
I know from some of the troubleshooting I have done so far that it is not Network settings and firmware or Software. This camera worked perfectly up until last week.
It also has a Reset button. I have already tried it and all the other basic stuff.
I believe it to be a Hardware error.
So my question is what would cause an IP camera to want to reboot after connecting but connecting without image?
Is there anyone that can shed some light to this? There are many people in this same booting. If you check the Foscam forum or google it, you will see that this makes a lot of people unhappy.
Please Help!
I know from some of the troubleshooting I have done so far that it is not Network settings and firmware or Software. This camera worked perfectly up until last week.
It also has a Reset button. I have already tried it and all the other basic stuff.
I believe it to be a Hardware error.
So my question is what would cause an IP camera to want to reboot after connecting but connecting without image?
Is there anyone that can shed some light to this? There are many people in this same booting. If you check the Foscam forum or google it, you will see that this makes a lot of people unhappy.
Please Help!
