I have two 24 vac inputs each driving a .3 amp solenoid.
I would like to tap each of these lines and produce an "OR" gate that will produce a single 24 vac output if/when either input is active.
The output should drive maximum 1.2 amp.
I would like the two inputs to remain electrically isolated from one another, as each is also driving a solenoid.
How can I go about this. I have no other power available except 110vac and 24vac.
thanks
I would like to tap each of these lines and produce an "OR" gate that will produce a single 24 vac output if/when either input is active.
The output should drive maximum 1.2 amp.
I would like the two inputs to remain electrically isolated from one another, as each is also driving a solenoid.
How can I go about this. I have no other power available except 110vac and 24vac.
thanks
