Hi,
I have tried to find someone local for this issue. Failed miserably.
So I'm going to attempt myself if I can get genuine help here. I hope it's the right place to ask and hope this goes successful.
I have a treadmill that has a faulty board. It goes "3" "2" "1" and then nothing, just "ERR"
The motor definitely works because I attached a 12 volt DC adapter and it was spinning super slow obviously but I didn't want to do anything that I have no idea about.
So, is it possible to attach the motor to another speed controller without the use of the board? It's chinese so I'll probably never find a replacement. I can't dish out another PLN100-300 for a new one so I'm hoping I can just get this going by spending on the parts only.
Any help will be great. Thanks
I have tried to find someone local for this issue. Failed miserably.
So I'm going to attempt myself if I can get genuine help here. I hope it's the right place to ask and hope this goes successful.
I have a treadmill that has a faulty board. It goes "3" "2" "1" and then nothing, just "ERR"
The motor definitely works because I attached a 12 volt DC adapter and it was spinning super slow obviously but I didn't want to do anything that I have no idea about.
So, is it possible to attach the motor to another speed controller without the use of the board? It's chinese so I'll probably never find a replacement. I can't dish out another PLN100-300 for a new one so I'm hoping I can just get this going by spending on the parts only.
Any help will be great. Thanks
