Compatible replacement for BMX-01 E226252 20x4 LCD with ST7063C-QG controller

I have one lcd module 20*4 BMX-01 E226252 (with 3 IC on module, IC No. is ST7063C-QG)
this part is obsolete now, i dont know how to replace this lcd with equivalent one, what parameter should be taking in mind when replacing lcd module.

Nimit Gandhi

Hi

When replacing LCD modules, it should match to what you need for display. What device does this LCD module used for? How many pins does it have?

Technically, an LCD module is something used for output. So, I suppose it would work if you just provide the required parameters.

Hi friend,

We are LCD/LCM manufacturer, welcome to visit our website: www.joinlcd.com, E-mail: sales(_at_)joinlcd.com.

Thank you very much for your interested in Welljoin. If you have any questions, please contact us with no hesitate,
we are sure any of your inquiry will get our prompt reply!

Try eBay.
Otherwise you are going to have to do some detective work. The unit has a form factor that is not common now I would think, so the mechanical side may be difficult to replicate. I assume it is going into an existing piece of equipment, so some mechanical work would be required.
The part on the board you list is the LCD driver, there should be another chip , the controller, which will have the external interface to the outside world, probably a parallel bus, you need to ascertain what that is, what voltage it works at, character set, etc. This should then be matched up with the controller on currently available boards,
cheers,
Richard