Interface Parallel with two analog sensor using 1 channel of ADC module

Hey I was going through some old forum but still not able find better solution, As I need to know that is it possible to use two analog sensor in parallel with 0-10v ADC(using only 1 channel) for sending digital output to Arduino nano? Require your intel on this, Thank you  

If you are asking if you can connect 2 sensors together and use a single input to an ADC the answer is "NO". At best one will load the other and you will get erroneous readings. At worst you may destroy one or both sensors. Although irrelevant to my answer above you don't mention whether they are the same type of sensor and why you would want to connect them in parallel.
The board you point to has a single ADC, but can read 4 channels through a multiplexer which switches the signal from one of the input channels to the ADC. Only one input channel can be active at a time.

Actually, depending on your sensor, it may be possible to  parallel them if you can enable to power top one at a time, but you have to know quite a bit bout the sensor before you can try it.