I want to modify a water sensor that has locations for a relay and the other additional components to interface it . This was designed to hold a 4 pin jack, but I cannot find any connectors with anything close to this hole pattern, which is 3.5 mm by 8 mm. Any suggestion for a style would be helpful. It is the 8 mm that is the challenge.
On the image it is J2. Both sides of the board are shown. It is at the top of the image, at the middle of the combined image. It should be right angle connector, facing the same way the RJ45 connector is.
On the image it is J2. Both sides of the board are shown. It is at the top of the image, at the middle of the combined image. It should be right angle connector, facing the same way the RJ45 connector is.
Attachments:
