How to Design Ethernet SPD with TVS, Gas Tube, and Digital Activation Indicator?

201 1

Report a violation of the law

Reply | New topic

#1 21684030 26 Feb 2020 19:22

david az david az

Anonymous

Post #1
21684030 26 Feb 2020 19:22

Hi

I want to design an Ethernet SPD ( surge protection) with indication.
like most of the SPD's I'm going to use a TVS ( for quick response) and a gas tube. what i need to add is an indication when a lighting hit the communication line and activate the SPD.
i want a digital pulse ( that i can count the numbers of activation with a controller) or if it not possible maybe a visual indicator.

Any ideas how to Design the above?

thanks
ADVERTISEMENT
#2 21684031 29 Feb 2020 22:53

Giovanni Di Maria Giovanni Di Maria

Anonymous

Post #2
21684031 29 Feb 2020 22:53

To detect lightings you can build a little and small tuning circuit below 300 Khz. You can amplify the signal received, and square it. Then you can count these impulses using a little MCU and a display.
Create an account, log in here. You will receive points by participating in discussions.
Join this discussion.

Install Elektroda application

Didn't find an answer? Ask Artificial Intelligence

*I agree to send the question to OpenAI, Anthropic PBC, Perplexity AI, Inc., Kagi Inc., Google LLC - owners of language models in order to prepare the best response. The companies may monitor and log information entered into the form.

*I agree to publicly display my question and answer. The question and answer will be publicly available to everyone. The process may take a few minutes. Upon completion, you will be redirected to the page with the answer.

Wait...(2min)

Reply | New topic

Report a violation of the law

How to Design Ethernet SPD with TVS, Gas Tube, and Digital Activation Indicator?

Didn't find an answer? Ask Artificial Intelligence