Filtering required when connecting multiple power modules to AC line

I picked up some TDKLamda 500W power modules PFE700-48 surplus and I want to use two of them to provide roughly plus and minus 52 volts to power a couple Class D audio power amplifiers. The datasheet hookup diagram shows a schematic connecting to the AC line through a couple common mode chokes and several capacitors to ground and across the line powering a single PFE700-48 module. But it doesn't cover the input filter set-up when using 2 modules.

Do I need to duplicate such a line filter for the AC input to EACH module, or can they share at least some components? These modules provide both power-factor correction and semi-regulation in the same module.

Here's a link to the shiny datasheet with the schematic on page 2.

http://www.us.tdk-lambda.com/ftp/specs/pfe.pdf

(The fatter 20 page datasheet shows the same hookup for the PFE700 series except some component value changes, but doesn't address the question).

Thoughts?

Bart

See this note,
http://www.vicorpower.com/documents/applications_manual/200VIJ00_Sect_09.pdf
The modules on the filter are different, but the comments are applicable,
cheers,
Richard

Thanks, Richard!

That was very helpful, including the discussion about noise conduction.

Bart