I have tried to wire this Single Point Level Switch and I have had no luck . Attached is the schematic. The output is a SPDT relay (10A @ 115 V). I am testing this with a DMM
Green is to 1, Black is to 2, white is to 3 . Are 2 and 6 internally connected??? If I measure with meter 3 and 6 shouldn't I get the same voltage as the input. If I I measure 2 and 4 I get a reading of 14V . Nothing happens when the probe hits the water. I know this is pretty vauge just looking for a little help .
Thanks
J
schematic
Green is to 1, Black is to 2, white is to 3 . Are 2 and 6 internally connected??? If I measure with meter 3 and 6 shouldn't I get the same voltage as the input. If I I measure 2 and 4 I get a reading of 14V . Nothing happens when the probe hits the water. I know this is pretty vauge just looking for a little help .
Thanks
J
schematic
