E-Max CMD vs Raw-1D Trip Circuit Monitors: Trip Coil vs 86 Lockout Relay Functions

I am trying to understand breaker logic for a feeder breaker to a 4160V switchgear. We currently have installed the E-Max CMD and Raw-1D trip circuit monitoring devices. We have one installed to monitor our trip coil and one installed to monitor our 86 lockout relay. 

I am unsure of what the function for these monitors is. After some internet searching, I have only discovered that they are supposed to monitor the integrity of the trip coil. I would like some more detail about how the devices operate and what information they are capable of sending out. I would also appreciate some incite as to what the differences between monitoring the trip coil and the 86 lockout relay might be if there are any.

P.S. I'm not entirely sure that I put this question in the right category. If any of you have any suggestions on which category might help me get the best help, I am open to suggestions.

Thank you all.

Bailey

First of all, have you checked its "datasheet("")":http://www.e-maxinstruments.com/images/pdf/product-catalog/E-MAX-RAW-Trip-Circuit-Monitor-2014.pdf? Second, the device 86(lockout relay) is required to facilitate multi-breaker tripping. Direct breaker tripping eliminates the delay incurred by an intermediate contact multiplying or lockout relay, thereby reducing the time to interrupt a fault. This may be advantageous where total fault interrupting time must be reduced to preserve power system stability or near critical customer loads that are sensitive to momentary voltage disturbances.

Thanks for the reply.

I have looked at the data sheet for this device in depth.

My main concern with this device is that it is sending information to a control system alarm. I am trying to understand how the E-Max works so that I can understand exactly what that alarm is trying to tell the operators. I would like to know things like: What is the normal operation of the device (i.e. when I am using its normally open or normally closed contacts, what is that telling me?)? and What is the operational difference between the CMD model and the Raw-1D model (again with concern placed on what the contacts are telling me)?

Thank you.