How to Use Two UCC37321 Drivers for IGBT Half Bridge in SSTC Tesla Coil Design

I’ve been tryin to get a sstc Tesla coil working and I have 2 UCC37321 mosfet driver and I’m not completely sure how I can put them together to driver the igbt I want the the design to be similar to the one Tesla schematic be without the gate driver transformer. I have already killed 2 of the UCC37321 chip and only have 2 left so please help

Hi Joaquin-You said you wanted to get rid of the gate drive transformer.  If that's the case, I think there is a simpler way to do this.  Take a look at the FAN7380 half-bridge gate driver chip.  It is intended to do exactly what you want- and they're not very expensive. Note that you will need an isolated 15 volt source, which you can easily get by usng a small DC-DC converter module like the SPU01.  You will also probably want to isolate the input signal using an optocoupler.-Rick