Hi everyone,
I'm pretty new to electromagnetism and have no experiences in this topic.
I have a signal generator (Digital Dual Channel Funktion Signal Generator) and want to generate two signals (530 and 550 Khz signal) and want to transmit these generated signals to the points on a table (see picture bellow) one by one.
I don't know, how a signal generator works. I think, when i generate a signal it transmits the signals to everywhere. But i want to send the signal only to certain points on table.
Option 1:
http://prntscr.com/nzoyha
The distance between the points on table and signal generator is one meter.
Option 2:
I can also build my signal generator directly under the table. I can chose which table i want to use. Is it then possible? Normally the distance between the points is 2 cm. How i can transmit the signal to each point from under the table?
My supervisor want that i have to send signal only to send that points. When the points receive the signal then they are moving. That's mean i only should send the signal to point which i want to move. That points have a embedded chip which only listens 530 and 550 khz frequency.
My signal generator is: https://www.amazon.de/gp/product/B07593GDB7/
Is that possible? if yes, how?
I'm pretty new to electromagnetism and have no experiences in this topic.
I have a signal generator (Digital Dual Channel Funktion Signal Generator) and want to generate two signals (530 and 550 Khz signal) and want to transmit these generated signals to the points on a table (see picture bellow) one by one.
I don't know, how a signal generator works. I think, when i generate a signal it transmits the signals to everywhere. But i want to send the signal only to certain points on table.
Option 1:
http://prntscr.com/nzoyha
The distance between the points on table and signal generator is one meter.
Option 2:
I can also build my signal generator directly under the table. I can chose which table i want to use. Is it then possible? Normally the distance between the points is 2 cm. How i can transmit the signal to each point from under the table?
My supervisor want that i have to send signal only to send that points. When the points receive the signal then they are moving. That's mean i only should send the signal to point which i want to move. That points have a embedded chip which only listens 530 and 550 khz frequency.
My signal generator is: https://www.amazon.de/gp/product/B07593GDB7/
Is that possible? if yes, how?
