Hello, I have a problem with the programming of the KUX-110 module, to the KLF 100 module. When adding a device to the KLF-100, I receive a message that a device has not been added,
Description of the addition according to the instructions:
I press reset on the remote control for 10 sec
then I move on to the automatic addition of devices to the KLF-100
after 1 min. the KLF-100 reports that a device could not be found
Description of the addition according to the instructions:
I press reset on the remote control for 10 sec
then I move on to the automatic addition of devices to the KLF-100
after 1 min. the KLF-100 reports that a device could not be found
